A complete small boat battery management system. Charge two batteries at or away from the dock.This Add a battery kit is similar to the Blue Sea 7649 (see related products) however this unit comes with 10 Amp BatteryLink Charger Model 7604. The...

The Add-A-Battery is as simple to operate as an ON-OFF switch, yet effectively manages the switching and charging of two batteries from a single charge source. The Add-A-Battery includes a Dual Circuit Plus Battery Switch and an Automatic Charging Relay...

The Add-A-Battery is as simple to operate as an ON-OFF switch, yet effectively manages the switching and charging of two batteries from a single charge source. The Add-A-Battery includes a Dual Circuit Plus Battery Switch and an Automatic Charging Relay...

Features Provides electrical insulation for exposed panel backs Provides mechanical protection for panel backs protruding into lockers Lightweight material is easily drilled for wire entrance and exit Meets ABYC requirements for panels with combined AC...

Blue Sea AC Rotary Switch Panel 65 A 2 positions + Off and 2 Pole as under 8357. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 2. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea AC Rotary Switch Panel 30 A 2 positions + Off and 2 Pole as under 8359. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 2. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea AC Rotary Switch Panel 30 A 3 positions + Off and 2 Pole as under 8358. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 3. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea 360 System Distribution Panel BS1217 is one of the most opular models but please contact us for more information on other configurations which may suit your requirements. Features Includes 4205 - square format label set Available with...

Features Isolates the Engine circuit from the House circuit Allows emergency cross connect between isolated battery banks Protects electronics from sags and spikes caused by engine cranking Specifications Number of positions: 3 Nominal voltage: 12 V...

Features Red reverse polarity indicating LED "ON" indicating LEDs installed in all circuit positions All hot, neutral and safety ground buses installed, fully pre-wired All circuit label positions are backlit on standard panels - No kit...

Features Red reverse polarity indicating LED Safety ground screw on panel back Combines switching and circuit protection into a single device "Trip Free" design cannot be held "ON" during fault current condition Specifications Nominal voltage: 230 V...

Blue Sea WeatherDeck Toggle Switches, all models. Features Specially manufactured by Carling Technologies for use in Blue Sea Systems' WeatherDeck® Panels When mounted with a WeatherDeck® Toggle Switch Boot Rated IP67-temporary immersion for 30...

Features Rated IP67 - temporary immersion for 30 minutes UV resistant material resists discoloration and cracking Replaces dress nut for mounting on WeatherDeck panel switches Specifications Colour: Black Thread size: 15/32"- 32" Weight: 0.02 kg (0.04...

Features Designed for flybridge and open cockpit applications Rated IP67 - temporary immersion for 30 minutes Independent label backlighting allows switching and dimming Compatible with all blue sea systems digital dimmers Each panel can be mounted in...

Features Designed for flybridge and open cockpit applications Rated IP67 - temporary immersion for 30 minutes Independent label backlighting allows switching and dimming Compatible with all blue sea systems digital dimmers Each panel can be mounted in...

Blue Sea WeatherDeck® Switch Panels are waterproof and rated IP67 (for temporary immersion in water) and use materials that won't deteriorate in the harsh sun, salt, and water. Many small boats, which already have circuit protection and do not run at...

Features Designed for flybridge and open cockpit applications IP67 - protected against immersion up to 1 m for 30 minutes Independent label backlighting circuit for remote switching and dimming Integrated ATO/ATC fuse based circuit protection Each panel...

Features ON-OFF contura switches ON indicating LED's embedded in switch Watertight mounting gasket Countersunk mounting holes throughout Two-part polyurethane slate gray finish Completely wired and ready to install Will withstand the water exposures...

Features ON-OFF contura switches ON indicating LED's embedded in switch Watertight mounting gasket Countersunk mounting holes throughout Two-part polyurethane slate gray finish Completely wired and ready to install Will withstand the water exposures...

Features ON-OFF contura switches Watertight mounting gasket ON indicating LED's embedded in switch Designed for flybridge and open cockpit applications Push button reset-only circuit breakers with waterproof boots Panel front is rated IP66-protected...

Features ON-OFF contura switches Watertight mounting gasket ON indicating LED's embedded in switch Designed for flybridge and open cockpit applications Push button reset-only circuit breakers with waterproof boots Panel front is rated IP66-protected...

Features ON-OFF contura switches Watertight mounting gasket ON indicating LED's embedded in switch Designed for flybridge and open cockpit applications Push button reset-only circuit breakers with waterproof boots Panel front is rated IP66-protected...

Features ON-OFF contura switches Watertight mounting gasket ON indicating LED's embedded in switch Designed for flybridge and open cockpit applications Push button reset-only circuit breakers with waterproof boots Panel front is rated IP66-protected...

Features Watertight mounting gasket ON-OFF-AUTO contura switch Completely wired and ready to install Designed for flybridge and open cockpit applications Fuse holders accept commonly available AGC and MDL glass fuses "ON" LED embedded in switch...

Features Economical Visible indication of blown condition Tin-plated connector blades for corrosion resistance Specifications Maximum voltage: 32 V DC Interrupt capacity: 1000 A Weight: 0.02 kg (0.04 lb) Dimension Drawing Trip Delay Curve Opening...

Blue Sea ATO/ATC Fuses with tin-plated connector blades for corrosion resistance and includes two fuses per pack. Features Two fuses per pack Fast-acting type fuses ideal for electronic devices Tin-plated connector blades for corrosion...

Bluesea 187-Series Circuit Breakers combine switching and circuit protection into a single device. Available in amperages 25-200A. Features Combines switching and circuit protection into a single device* Clear, single lever operation "Trip Free" design...

Bluesea 187-Series Circuit Breakers combine switching and circuit protection into a single device. Available in amperages 25-200A. Features Combines switching and circuit protection into a single device* Clear, single lever operation "Trip Free" design...