Laser Rudders and Centreboards

ILCA or Laser tiller retaining pin to secure the tiller to the rudder head, supplied with securing cord Note If your tiller is not drilled to receive the retaining pin, ensure the tiller is firmly pressed into the head before drilling the location hole...

A rudder ring is a must if you would like to keep your Rudder. It provides a secondary attachment of the rudder to the hull preventing detachment. Make sure you have a rudder ring fitted to save you money in the future.

The Inexpensive, clear hard plastic profiles which fit over the traling edge of the Laser daggerboard and rudder. Protects your Laser foils from damage in storage or transportation. Specifications Material: Plastic Colour: Clear

ILCA Laser Centreboard Stop Set by Holt How to assemble Allign the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of cap  Fit the part assembled unit to the centreboard and then align and...

The Laser Rudder Clip will secure the Laser Rudder to the boat. The Rudder Clip is easy to fit but remember to use Sikaflex to keep the hull watertight.

The Laser Friction Pad MK2 is screwed to the back of your daggerboard casing and allows for perfect grip and slip ratio when raising the board.

The MK1 flat back rubber friction pad for the deck of any Laser dinghy designed as a friction plate to keep the Laser daggerboard in place during sailing.

The Laser gudgeon is a small plastic female piece that goes onto the back of your Laser dinghy. The rudder head fits onto two of these gudgeons which are screwed (screws supplied separately) to the transom holding it in place. The rudder is then held in...

This ILCA / Laser tiller retaining pin secures the tiller to the rudder head. Note If your tiller is not drilled to receive the retaining pin, ensure the tiller is firmlypressed into the head before drilling the location hole to ensure solid fit

The Laser rudder head is a aluminium construction complete with a rudder ring and tilller retaining pin. Rudder fittings are stainless steal for long lasting, please make sure you rudder head has the approve sticker for eventing. Comes with rudder...

The Laser XD rudder head pivot bolt is an upgraded large diameter bolt and nylock nut with 20 mm washers. The rudder bolt will hold your rudder blade firmly in place.

Laser Infused Rudder is a GRP foil that is race legal, this is just the blade and wil require a stock.

Laser shock cord retainer with plastic clip keeps dagger board in place. Specifications Colour: Black Length: 7 mm

Laser Performance Daggerboard Infused.