ILCA Laser Daggerboard Stop Sets

ILCA Laser Centreboard or Daggerboard Stops - These push-together sets prevent the Daggerboard dropping too low 

How to assemble

1. Allign the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of cap 
2. Fit the part assembled unit to the centreboard and then align and snap-on-second cap
3. The Caps have faired side to fit the faired angle on centreboard - Make sure the allignment is correct before doing the final squeexe of the end caps to ensure a perfect fit

Tip : The caps require a fair amount of pressure to snap-on. Place one side of the set on a wooden board and push down from the other side with a heavy weight or even use you heel

It requires a smooth firm pressure but do not use a hammer