Autopilots & Tiller Pilots

The Navico Simrad WR10 allows you to take control of your autopilot from anywhere on board with this easy to use, pocket size, wireless remote controller. Perfect for all types of motor and fishing boats. A simple process to engage or disengage gives you...

The Simrad TP10 delivers reliable auto steering for boats with tillers up to 32' in length. Simple, straightforward controls and a precise steering system - normally only found on higher-end models - combines in a quiet package with extremely low power...

The Simrad TP22 is a reliable and robust autopilot for tiller steered boats up to 34ft in length. Low power draw and precise steering capabilities couple together with minimal noise, allowing you to enjoy some smooth sailing. Key Features Easy To UseA...

The Simrad TP32 is a reliable and robust sailing boat autopilot, which has been optimised to draw as little power as possible and operate extremely quietly, making it ideal for sailboats up to 37ft. Features Easy To Use - A simple selection of controls...

Raymarine Evolution Hydraulic Package  T70157 In the Pack  EV1 Sensor Core The EV-1 is designed for Evolution mechanical and hydraulic autopilot systems. SeaTalkng networking enables a single cable connection for power and data to the...

Simrad PB60 Tiller Pilot pedestal brack with 60mm Upstand - a required anchor point accessory to install Simrad Tiller Pilots to a horizontal surface in the cockpit. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad 60mm extension piece to extend shaft of Simrad Tillerpilots, allows fine adjustment in fitting the unit to achieve best toller centre position. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad 30mm extension piece to extend shaft of Simrad Tillerpilots, allows fine adjustment in fitting the unit to achieve best toller centre position. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad SKT100 through bulkhead 2 pin waterproof plug and socket to connect power supply to the Tiller Pilot  Features Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad PB30 Tiller Pilot pedestal brack with 30mm Upstand - A required anchor point accessory to install Simrad Tiller Pilots to a horital surface in the cockpit Features Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad CB1 Cantilever Bracket - Required anchor point accessory used to attach a Simrad Tiller pilot to a vertical surface. Features Adjustable length: 135-240 mm. Suits Simrad Tiller Pilots Backplate and screws included

Simrad Bracket TB30 connects the tiller pilot to the tiller - The TB30 has a 30mm drop between the the bottom of tiller and bracket at the connection point