Switching & Connectivity

Features Provides electrical insulation for exposed panel backs Provides mechanical protection for panel backs protruding into lockers Lightweight material is easily drilled for wire entrance and exit Meets ABYC requirements for panels with combined AC...

Blue Sea AC Rotary Switch Panel 65 A 2 positions + Off and 2 Pole as under 8357. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 2. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea AC Rotary Switch Panel 30 A 2 positions + Off and 2 Pole as under 8359. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 2. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea AC Rotary Switch Panel 30 A 3 positions + Off and 2 Pole as under 8358. Fully wired and ready for installation. Blue Sea 230 V AC Source Selector Switch Panel with rotary switch x 3. If either the Blue Sea Switch front or back is to be exposed...

Blue Sea 360 System Distribution Panel BS1217 is one of the most opular models but please contact us for more information on other configurations which may suit your requirements. Features Includes 4205 - square format label set Available with...

Features Isolates the Engine circuit from the House circuit Allows emergency cross connect between isolated battery banks Protects electronics from sags and spikes caused by engine cranking Specifications Number of positions: 3 Nominal voltage: 12 V...

Features Red reverse polarity indicating LED "ON" indicating LEDs installed in all circuit positions All hot, neutral and safety ground buses installed, fully pre-wired All circuit label positions are backlit on standard panels - No kit...

Features Red reverse polarity indicating LED Safety ground screw on panel back Combines switching and circuit protection into a single device "Trip Free" design cannot be held "ON" during fault current condition Specifications Nominal voltage: 230 V...

Blue Sea WeatherDeck® Switch Panels are waterproof and rated IP67 (for temporary immersion in water) and use materials that won't deteriorate in the harsh sun, salt, and water. Many small boats, which already have circuit protection and do not run at...

The Blue Sea Contura Switch Mount is perfect for installing up to 3 switches on a dashboard or fly bridge. The switches clip in and are sealed with the gasket supplied with the Switch. The outer side of the mount should be sealed if required to be...

Use this Roca Carling Blank Switch Cover to block up unused sockets in your switch panel. Fits the Roca panels (see related products).

As under Roca part no: 466060. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for windlass switches. These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466036. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for windlass switches. These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466036. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for windlass switches. These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466067. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for Bilge pumps. The bilge Switch has 1 on the label so this can be used for a main or primary bilge pump.These actuators do not...

As under Roca part no: 466024. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for trimtab controls.These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for any Roca LED Lights. This switch label is blank but comes with a light window.These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466025. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for fans.These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466066. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for interior lights. These actuators do not work with Rule or Bluesea Switches. Only use with Roca.

As under Roca part no: 466034. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for labelling anchor lights. The Anchor Light Switch is recommended for 2 postion on-off switches (see related products).These...

As under Roca part no: 466067. These plastic Roca Actuators fit the Roca Carling Switches (see related products) suitable for Bilge pumps. The bilge Switch has 1 on the label so this can be used for a main or primary bilge pump.These actuators do not...

Carling switch actuator with Bilge Pump decal - Can be used with illuminated or non-illuminated Carling marine switches.

A fully waterproof Carling Switch with Red LED when activated useful as a marine navigation lights or fan switch. A waterproof Carling Switch suitable for pumps, anchors and more. This switch has three positions: On, Off and On. This can be useful as a...

A fully waterproof Carling Switch useful as a light switch. A waterproof Carling Switch suitable for pumps, anchors and more. This switch has two positions: Off and On. This can be useful as a switch for marine lights. The switch actuator is sold...