Autopilots & Tiller Pilots

Pair this sensor with the GHP™ 20 or GHP 12 to provide rudder position feedback and to detect and avoid rudder stops while sailing or boating. The GRF 10 uses a magnetic sensor to relay position information, eliminating...

Provides secure autopilot control and setup from its dedicated keypad. As the primary Pilot controller, or as a second station to a Zeus chartplotter, the Pilot Controller provides assured control and feedback via its high-resolution display. Key...

The Simrad TP22 is a reliable and robust autopilot for tiller steered boats up to 34ft in length. Low power draw and precise steering capabilities couple together with minimal noise, allowing you to enjoy some smooth sailing. Features Easy To UseA...

Simrad PB60 Tiller Pilot pedestal brack with 60mm Upstand - a required anchor point accessory to install Simrad Tiller Pilots to a horizontal surface in the cockpit. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad 60mm extension piece to extend shaft of Simrad Tillerpilots, allows fine adjustment in fitting the unit to achieve best toller centre position. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad 30mm extension piece to extend shaft of Simrad Tillerpilots, allows fine adjustment in fitting the unit to achieve best toller centre position. Suits Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad PB30 Tiller Pilot pedestal brack with 30mm Upstand - A required anchor point accessory to install Simrad Tiller Pilots to a horital surface in the cockpit Features Suits Simrad Tiller Pilots TP10,TP22 & TP32

Simrad CB1 Cantilever Bracket - Required anchor point accessory used to attach a Simrad Tiller pilot to a vertical surface. Features Adjustable length: 135-240 mm. Suits Simrad Tiller Pilots Backplate and screws included