Bluesea, Model 4322, water resistant  6 circuit breaker, switch panel with illuminated display and grey trim - Designed for exposed mounting positions, this new range of circuit breaker panels from BlueSea is water resistant to IP66 and a very cost...

Bluesea 7220 A-Series Black Toggle Circuit Breaker - Single Pole 30A. Features Meets american boat and yacht council (ABYC) standards The industry standard circuit breaker for Blue Sea Systems" electrical panels Combines switching and circuit protection...

Features Meets american boat and yacht council (ABYC) standards The industry standard circuit breaker for Blue Sea Systems" electrical panels Combines switching and circuit protection into a single device "Trip Free" design cannot be held "ON" during...

Bluesea Water Resistant Circuit Breaker 4 Switch control with illuminated display camo trim. Designed for exposed mounting applicationsFeatures Illuminated 15A circuit breakers provide switching, “ON” indication and overcurrent...

Features Ignition protected (conforming to SAE J1171)- safe for installation aboard gasoline powered boats (35-500 A only) Silver-plated connector blades for corrosion resistance Visible indication of blown condition 6,000 Ampere Interrupt Capacity...

Blue Sea 12 volt DC Distribution Panel with 8 x A-Series Flat Rocker Circuit Breaker - Single Pole 15A. Specifications Positions: 8 Nominal Voltage: 12V DC Maximum amperage ratings are dependent on use of appropriately sized fuses and wire for a given...

Blue Sea DC Distribution Panel for 12 or 24v with 5 Supplied 15A Cicruit Breakers and 3 blank positions. Features 5 Supplied 15A Cicuit Breakers with position for 3 others of choice All positive, negative and grounding buses installed Fully...

Blue Sea 230V AC Distribution Panel with Voltmeter and Ampmeter, and 3 x 15A Circuit Breakers. Features Red reverse polarity indicating LED All hot, neutral and safety ground buses installed, fully pre-wired All circuit label positions are backlit on...

SafetyHub 150 Fuse Block is an ignition protected fuse block with screw termination safe for use on gasoline powered boats. Features Accepts four AMI or MIDI fuses for high-amp circuits up to 200 A Accepts six ATO or ATC Fuses for circuits up to 30 A...

CableClam Provides a waterproof pass-through for antenna cables without requiring removal of the factory installed connector. Features Perfect for antenna installation Waterproof co-axial installation without removing connectors Save the expense of...

The Easiest, Fastest, Most-Reliable Knife & Tool Sharpener in the World. Finally, a knife sharpener anyone can use! In about 10 seconds, sharpen knives (even serrated knives), cleavers, axes, machetes, and many other cutting tools.

ML-ACR Automatic Charging Relay with Manual Control is 500 A magnetic latching (bi-stable) relay automatically combines batteries during charging and isolates batteries when discharging and when starting engine. Features Senses charging on two battery...

Automatically combines batteries during charging, isolates batteries when discharging and when starting engines. Features Dual sensing Designed for 12 V or 24 V systems 12/24 V auto ranging voltage input Hermetically sealed contacts/vaporproof Supports...

Blue Sea DC Micro Voltmeter backlit meter face (separate 12 or 24 V DC backlight connections). Specifications Face size: 2" (50.8 mm) Function: 8 V to 16 V Backlighting amperage: 16 mA @ 12 V DC, 20 mA @ 24 V DC Meter current: 1 mA at full scale Weight:...

The Blue Sea Multi-Meter 8110 measures AC/DC current without having to interupting circuits or contacting live terminals. True RMS - required for accurate measurement of inverter output Data hold - press "HOLD" button during measurement to lock reading...

Features Busbars are used to consolidate multiple wires or feed multiple circuits Insert molded stainless steel studs eliminate need for securing nut and allow high torquing for excellent electrical contact Raised bus provides easy access to multiple...

Specifications Base material: UL 94-V0 rated, glass reinforced thermoplastics Bus material: Tin-Plated copper CDA 110/UNS11000 Maximum voltage: 300 V AC/48 V DC Number of terminal stud: 8 Terminal type: 3/8"-16 Stud Terminal stud torque: 15.82...

Specifications Base material: UL 94-V0 rated, glass reinforced thermoplastics Bus material: Tin-Plated copper CDA 110/UNS11000 Maximum voltage: 300 V AC/48 V DC Number of terminal stud: 4 Terminal type: 3/8"-16 Stud Terminal stud torque: 15.82...

Provides a termination point for extending the length of outboard harnesses or other conductors. Designed for connecting high amp conductors Includes one black and one red insulator Specifications Colour: Black, Red Maximum voltage: 48 V DC Mounting:...

Provides a termination point for extending the length of outboard harnesses or other conductors. Designed for connecting high amp conductors Includes one black and one red insulator Specifications Colour: Black, Red Maximum voltage: 48...

Eliminates chage and provides strain relief when passing high current through hulls, decks and bulkheads. Features Rated IP66 - withstands water from heavy seas Perfect for passing high current cables through hulls, decks and bulkheads Large cables...

Eliminates chage and provides strain relief when passing high current through hulls, decks and bulkheads. Features Rated IP66 - withstands water from heavy seas Perfect for passing high current cables through hulls, decks and bulkheads Large cables...

Eliminates chage and provides strain relief when passing high current through hulls, decks and bulkheads. Features Rated IP66 - withstands water from heavy seas Perfect for passing high current cables through hulls, decks and bulkheads Large cables...

Eliminates chafing and provides strain relief when passing high current through hulls, decks and bulkheads. Features Rated IP66 - withstands water from heavy seas Perfect for passing high current cables through hulls, decks and bulkheads Large...

Enables connection of multiple smaller wires in spaces where a traditional bus bar may not fit. Base material is black nylon 8231 GHS Connects high amperage cables securely 150 A bus allows small wire connections at high amperage cable...

Insulated single stainless steel stud terminates multiple large conductors. Base Material is PBT UL94 V0 Connects high amperage cables securely Specifications Colour: Red Base material: Reinforced thermoplastic Maximum voltage: 48 V DC Stud dimension:...

Insulated single stainless steel stud terminates multiple large conductors. Base material is PBT UL94 V0 Connects high amperage cables securely Specifications Colour: Red Base material: Reinforced thermoplastic Maximum voltage: 48 V DC Stud dimension:...

These are very small terminal blocks and are typically used for electronics interfacing such as NMEA and other data connections where their compact size allows a large number of connections in a small space. They take a connector with a 6 hole to match...

Features Each screw pair is one isolated circuit Jumpers allow creation of common circuits Closed back design completely insulates power from the mounting surface Specifications Base material: UL 94 V0, PC Bus material: Nickel-Plated brass Screw...

Features Each screw pair is one isolated circuit Jumpers allow creation of common circuits Closed back design completely insulates power from the mounting surface Specifications Base material: UL 94 V0, PC Bus material: Nickel-Plated brass Screw...

These are very small terminal blocks and are typically used for electronics interfacing such as NMEA and other data connections where their compact size allows a large number of connections in a small space. They take a connector with a 6 hole to match...

Features The industry standard busbar for positive distribution The industry standard busbar for the collection of negative or AC ground circuits Specifications Base material: UL 94-V0 rated, glass reinforced thermoplastics Bus material: Tin-Plated...

Features The industry standard busbar for positive distribution The industry standard busbar for the collection of negative or AC ground circuits Specifications Base material: UL 94-V0 rated, glass reinforced thermoplastics Bus material: Tin-Plated...

Specifications Weight: 0.01 kg (0.02 lb) Certification: CE Base Material: Reinforced Polycarbonate Cover Material: Clear Polycarbonate Continuous Amperage: 100 Amperes AC/DC Voltage Rating: 300 Volts AC Maximum / 48 Volts DC Maximum Bus Material:...

The 2715 Cover is specifically designed for the BusBar models 2301 and 2303, providing a protective shield for these components. Features Lightweight yet durable construction, weighing 0.08lb (0.04 kg), ensuring optimal protection without adding...

In an electrical power system onboard a boat, the busbar is a bar of tin-plated copper that conducts electricity within a switchboard, distribution board, substation, battery bank, or other electrical apparatus. Blue Sea Mini Bus Bars 2305 are marine...

In an electrical power system onboard a boat, the busbar is a bar of tin-plated copper that conducts electricity within a switchboard, distribution board, substation, battery bank, or other electrical apparatus. Blue Sea Bus Bars 2302 are marine...

In an electrical power system onboard a boat, the busbar is a bar of tin-plated copper that conducts electricity within a switchboard, distribution board, substation, battery bank, or other electrical apparatus. Blue Sea Bus Bars 2301 are marine...

Easily add 4 fused circuits to the terminal of a battery provides power to new accessories in your boat or vehicle. Features Mounts on the battery terminal stud Screw terminals for securing wires Nylon insulated ring terminals included for each screw...

Consolidates branch circuits and in-line fuses Can be used for 24 hour circuits Tin-plated copper buses and fuse clips Accepts ring or snap fork type terminals Accepts ATO/ATC fast acting blade fuses Models available with or without a cover Positive...