ILCA Laser Rudders & Centreboards

Complete package of Laser® and ILCA® protection for maststep, mast, tiller, outhaul and daggerboard. Contains 2 disks for the maststep, 2 stripes for the maststep and mast deck, 2 stripes for snug fit of the top mast section, 1 stripe for the...

ILCA/Laser Tiller composite construction including flexible joint and rudder down cleat - Class legal for ILCA events. Features Flat plate design Composite carbon fibre and epoxy Includes RWO tiller joint

High quality GRP infused ILCA /Laser Daggerboard to suit all model ILCA Dinghies - Fully approved for use in ILCA events from Olympics to Provincials. With re-inforced trailing edge.

ILCA Laser Centreboard Stop Set by Holt How to assemble Align the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of cap  Fit the part assembled unit to the centreboard and then align and...

The ILCA Laser rudder retaining clip prevents the rudder popping up and becoming detached. The rudder clip is easy to fit but remember to use Sikaflex or similar sealant to keep the hull watertight. Features Will secure the rudder to the transom You can...

ILCA Laser Centreboard or Daggerboard Stops - These push-together sets prevent the Daggerboard dropping too low. How to assemble Align the first cap fitting to the centre shaft and push down hard to until the shaft is flush with outer side of...

Laser Rudders Gudgeons by Holt - 2 Required per boat  Fasteners 2 x Sowester Pan Head Self Tappers per Gudgeon - Size  8 x 1 1/2"  Select size here

Replacement gudgeon for the ILCA dinghy and Laser sailboat. Two of these are mounted on the transom of the boat and used for attaching the rudder head. Installs with 4 screws (not included). Sold individually and made from a heavy duty plastic for long...

This ILCA / Laser tiller retaining pin secures the tiller to the rudder head. Note If your tiller is not drilled to receive the retaining pin, ensure the tiller is firmly pressed into the head before drilling the location hole to ensure solid fit.

Official ILCA Rudder Head comes with rudder megabolt. Suits all models ILCA 4, 6 & 7 and Laser 4.7, Radial and Full Rig.

Older style articulated stainless steel tiller joint for smaller sailing dinghies

High quality, reliable RWO Omniflex Tiller Joint to suit most dinghy tiller extension, including ILCA Laser, Topper, and many others. This Omniflex joint is made from Elastomeric polymer which allows all directional flexibility. The fitting includes a...

The ILCA Mega Bolt is the pivot bolt to fit the Rudder Head to the Rudders Plade - Supplied with 20mm Washers.

Official ILCA fused rudder blade only - Suits all Rigs and Class legal for all ILCA events. Features Infused GRP rudder blade - blade only Fits the ILCA rudder head Note Also suits Laser (Torch logo) Sailboats.