Rule 500 Submersible Bilge Pump Auto - Model 25SA-24 - 24volt

The Rule 25SA-24 automatic bilge has a computerised operation and checks for water every 2 1/2 minutes and keep bilge water at the lowest level of any automatic bilge pump. A standard pump and float switch allows water to reach 2" (5cm) before it activates. Rule automatic bilge pumps activate at 5/8" (1.6cm)and drain water down to 1/4" (0.6cm).

Note: Requires a Rule 3 Way Panel switch to complete install

Features

• Fully automated bilge pump with computerised operation.
• Higher Flow — optimized impeller to provide greater flow at the same amperage
• Back Flow Prevention — reduces the amount of water flowing back into the bilge, reducing odor and helping keep your bilge cleaner
• Hidden Air Vents in the Body — helps prevent air locking in challenging plumbing installations
• Threaded Discharge — allows for different discharge port size
• Tough plastic body with integral strainer.
• Quick release strainer allows rapid cleaning.

Specification

• Voltage: 24volt
• Amps @ 24v: 0.8amp
• Fuse Size: 2(amp)
• Connections: For 19mm (3/4") bore hose
• Output: Up to 31 litres/minute (7 gallons/minute)
• Wiring : 3 Wire System – Requires On-Off-Auto Panel Switch to compete install 
• Output: Up to 31 litres/minute (7 gallons/minute) at 12v, without check valve.
• Max. recommended discharge head 2m

Dimensions

• Dimensions: 107mm high, 64mm long, 74mm wide.